Trendnet TEW-424UB Instrukcja Użytkownika

5 5. After finish the installation, plugged in the Wireless LAN USB 2.0 Adapter, you will see Wireless Configuration Utility Country Selector, select

6 Wireless Utility Setting With the Wireless USB 2.0 Adapter utility, users can configure all the functions provided by the Wireless Monitor Utility.

7 Configuration The Configuration function helps you to configure the Network and the Security. Network: the setting of the Network mode, the SSID an

8 ¾ Encryption Mode: There are two kinds of encryption mode, WEP encryption and WPA-PSK. Click the Enable Encryption to activate the security of the

9 WPA-PSK: WPA-PSK (Wi-Fi Protected Access pre-shared key) is a simpler version that does not support 802.1x and requires a separate RADIUS server fo

10 Advanced The Advanced settings help you to control the Wireless Adapter to adjust with wireless devices in certain environment. ¾ Transmit Rate:

11 ¾ Preamble Type: The usage of the preamble is to limit the packet size of the data to transmit. It is recommended to choose the short preamble whe

12 Profile The Profile section allows you to set values for all parameters by selecting a previously defined profile. Type a name in the Profile Name

13 Network The screen shows all the Wireless devices around your Wireless Adapter. The information of the wireless devices includes the SSID, MAC Addr

14 Statistics The Statistics section shows the real-time transmit and receive packets of the Wireless Adapter.

i Regulatory notes and statements Wireless LAN, Health and Authorization for use Radio frequency electromagnetic energy is emitted from Wireless LAN d

15 About The About section shows the Device Name, Regulatory Domain, Driver Version, MAC Address and the Utility version.

16 TECHNICAL SPECIFICATIONS General Standards IEEE 802.11g, USB 2.0, 1.1, 1.0 Radio Technology IEEE 802.11b Direct Sequence Spread Spectrum (DSSS) I

Limited Warranty TRENDware warrants its products against defects in material and workmanship, under normal use and service, for the following lengt

Technical Support You can find the most recent driver/firmware/software and user documentations on the TRENDware website http://www.trendnet.com.

ii The radiated output power of this Wireless LAN device is far below the FCC radio frequency exposure limits. Nevertheless, this device shall be used

iii The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-

iv TABLE OF CONTENT Introduction ... 1 Overview of this U

1 INTRODUCTION Congratulations on your purchase of this IEEE 802.11g Pen Size Wireless USB 2.0 Adapter. This manual helps to get familiar with the Pen

2 UNPACKING AND SETUP This chapter provides unpacking and setup information for the Wireless USB 2.0 Adapter. Unpacking Open the box of the Pen Size W

3 HARDWARE INSTALLATION LED Indicator LNK (LINK) The LNK indicator lights green when the Wireless LAN is connected to a network successfully. Otherwis

4 SOFTWARE INSTALLATION This section will lead you to install the driver and utility of the Wireless USB 2.0 Adapter. Windows 98se/ME/2000/XP Utility